Loading... Please wait...

Motor Mount / Landing Feet for 8.5mm Brushed Motors (Qty 4) made from TPU (Carbon Fiber Frame not included)

Hover over image to zoom

  • Image 1
  • Image 2
  • Image 3
  • Image 4
Plastic Spider Designs
$3.00

 Product Description

These Motor Mounts / Landing Feet are designed to friction fit in a 10mm hole and hold the motor tight.  There is a gap in the bottom of the landing feet to allow wire connectors to pass thru and they are notched to allow a rubber band to be wrapped around the underside of the frame to hold the wires off the ground.

Instructions.

  1. Press motor mounts thru hole in frame thru the bottom of the frame until they snap into place between the 2 grooves in the mount.  Face the largest opening in the feet towards the middle of the frame.
  2. Thread motor wire through the mount from the top.
  3. Press motor into mount until it bottoms out.  Be careful not to pinch your wires.
  4. Optionally bend the wires upwards and place a tiny rubber band around the bottom of the mount and the wires to hold it off the groud.
  5. The mount should now be tight within the frame and not easily move. 

Specifications

  • Each mount weighs .3 grams (Set of 4 weighs 1.2 grams).
  • Mount is made from Flexible TPU
  • Mount is designed for 8.5mm Brushed Motors.
  • Mount is designed to fit a 10mm hole in frame (Contact us if you are looking to fit a different sized hole or motor).

 Find Similar Products by Category

 Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

You Recently Viewed...

 

newsletter

Follow us on

Copyright 2017 Plastic-Spider. All Rights Reserved.
Sitemap | BigCommerce Premium Themes by PSDCenter

Click the button below to add the Motor Mount / Landing Feet for 8.5mm Brushed Motors (Qty 4) made from TPU (Carbon Fiber Frame not included) to your wish list.