Loading... Please wait...

HS1177 Camera Mount for Vortex 250 Pro (Free Download)

Hover over image to zoom

  • Image 1
  • Image 2
  • Image 3
  • Image 4
$0.00

 Product Description

HS1177 Camera Mount for Vortex 250 Pro (Free Download).  

This is required to be printed with Flexible TPU.  If you print using ABS or PLA it will split when you try to put it over the standoffs because it is purposely tight around the standoffs in order to not move or vibrate

If you do not have a printer and would like to buy the mount for $5.00 from Great 3D it can be ordered here.  
http://great3d.com/hs1177-camera-mount-for-vortex-250-pro-made-from-tpu/
If you are in the UK or Europe you can buy the printed mount from here.  
http://multirotorspares.co.uk/hs1177-camera-mount-for-vortex-250-pro-made-from-tpu/

 

Instructions for mounting:

  1. First take note that the mount has 2 ways it can be mounted.  One side up it will put the HS1177 mounting screws 10.75mm above the bottom plate and the other side up it will put them 11.75mm above the bottom plate.  By mounting the cam with the screws 10.75mm above the bottom plate you will get more angle from the cam but the cam will be about even with the bottom plate while turning the mounts over you will raise the cam 1mm for better protection but will get less angle.
  2. You can choose to mount the cam to the mounts before placing them over the standoffs or place them over the standoffs and then mount the cam.  I personally find it easier to mount the cam first without tightening down the screws too much.  This mount is designed to be very tight over the standoffs so you do not get play in the camera after it is mounted.
  3. Once mounted hold the camera at the angle you want and snugly tighten down the mounting screws (be careful not to tighten so tight that you strip them out.

If you do happen to strip out your mounting holes on the case a new case can be purchased at Surveilzone for $1.99 at the following link.
http://www.surveilzone.com/ultra-light-plastic-case-mini-sony-600tvl-camera-with-bracket-pa1217

This should also be compatible with the RunCam Swift Camera as the dimensions are the same.  It has not yet been tested with this camera.  If you buy this mount and use a RunCam Swift please let us know how it works for you.

License Information: 

HS1177 Camera Mount for Vortex 250 Pro (Free Download) by pLaStIcSpIdEr is licensed under the Creative Commons - Attribution - Non-Commercial license.  This means you can print this for your own use, print it for your friends but please do not print to sell.  If you make any changes to this design and post them for download please attribute the original design to "Robert Wheeler" or "pLaStIc sPiDeR Designs" or both.  

 Find Similar Products by Category

 Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

You Recently Viewed...

 

newsletter

Follow us on

Copyright 2017 Plastic-Spider. All Rights Reserved.
Sitemap | BigCommerce Premium Themes by PSDCenter

Click the button below to add the HS1177 Camera Mount for Vortex 250 Pro (Free Download) to your wish list.